Contact

egeplast

egeplast piping systems for the transport of drinking water

Permeation resistant piping system to protect drinking water in contaminated grounds

SLA® Barrier Pipe

The SLA® Barrier Pipe system reliably prevents the permeation of pollutants. The metallic permeation barrier enables permanent protection of sensitive media and the environment. In addition the electrical properties also provide the possibility of detecting the pipe and an integrity check after installation.



Protective piping system for damage-free installation

SLM® 3.0

SLM® 3.0 piping system is a patented, multi-layered protective piping system of the latest generation. When installed by means of alternative installation techniques, the protective pipe ensures the grid operator longevity and efficiency. Engineering offices and contractors verify flawless planning with this piping system.



Piping system with integrated quality test for closed construction


SLM® DCT

SLM® DCT is a piping system of PE 100-RC with additional protective layer and integrated conductive strips. These enable testing of the piping system for integrity directly after installation. In addition, they offer the possibility of permanent detection of the installed line.



High pressure PE piping systems


HexelOne® SLM

egeplast HexelOne® SLM pipe is a self-reinforced high pressure pipe, a monocomposite only from polyethylene. This reinforcement enables new areas of application in the “raised pressure“ area, in other words, operating pressures above applications previously covered using PE pipes. The reason: It indicates twice as high a strength compared to the previous PE pipes.



Factory-folded PE pipes for close-fit-lining


egeLiner®

egeLiner® is a polyethylene pipe for limited spaces at the jobsite. It is deformed and folded by means of a special thermomechanical treatment during manufacture. Long lengths, even with larger dimensions, can be wound on to drums due to the reduced cross-section. For the redeformation process, the egeLiner® is warmed up with steam after installation. The memory effect activated in this way causes the PE pipe to regain its original round form. The new pipe now lies as a static independent pipe, close-fit against the old pipe.



Axially force locking spigot and socket system made from PE


egeMDR

egeMDR is a pressure piping system of polyethylene with an axially force locked spigot. It offers short installation and processing times at full pressure resistance. In addition, installation can take place independent of temperature and weather.



Permanently or intermittend monitored piping system that finds and reports damages


3L Leak Control

The 3L safety pipe system provides a 100% leakage monitoring for soil and water protection.  It has been designed to report and locate damages – even on a mains-independent basis – and can be accessed and controlled in real time via the internet. A monitoring unit conntected to the pipe emits an alarm even by the smallest damage to the pipe. Messages will be sent directly to the control centre or to the smartphone. It can automatically switch off connected pump systems, thus preventing disasters reliably and at an early stage.



Economical because of abstaining from the use of sandbeds


9010 RCplus

9010®  RCplus  is a piping system of PE 100-RC with stripes or with an outer layer, dimensionally integrated and coloured, to identify the medium. Due to the high resistance of the PE 100-RC-material to stress cracks, a protective pipe bed zone of sand can be avoided without any loss of safety or durability. The 9010® RCplus  is suitable for open trench installation with and without sandbed as well as installation by ploughing and milling.


 

Components and moulded parts according to specifications


egeFit® components

egeplast offers segmented moulded parts, manufactured from piping, also designed according to the pressure class and requirements. All moulded parts can be delivered in the desired function (SLA®, DCT, 3L, egeSlurry® or similar). Entire assemblies, consisting of pipe and/or moulded parts, can be designed and prefabricated according to customer specifications, in order to facilitate your work at the jobsite.


You need help choosing the right pipe system? Our experts are happy to help.