egeFit® egeMDR
The egeMDR push-fit connection is a proven and practical alternative to conventional welding that has already established itself in potable water supply over decades. By eliminating the need for special welding equipment, it enables extremely fast, weather-independent installation, especially for small sections, while maintaining full flexibility, leak-tightness, and pressure resistance. This makes it the ideal solution for utilities that do not have their own PE welders.
Your advantages at a glance
Push-fit installation in seconds without complex welding or processing equipment.
Problem-free installation at any temperature, in any weather, and even with residual water in the pipe.
Simple installation that requires no special PE welder training.
Permanently leak-tight, restrained, and extremely pull-out resistant – without any additional thrust blocks.
The usual pipe flexibility and full pressure resistance are fully maintained as an alternative to welding.
Technical Data
Material:
PE 100-RC
Dimension:
OD 90 mm to 225 mm
SDR:
SDR 11 (SDR 17 on request)
Design:
Seamless bends (11° to 90°), tees (equal/reduced), E-pieces, and couplings; with one-, two-, or three-sided push-fit sockets
Radius:
r ≈ 1.5 x d (for bends)
Further technical details:
For potable water (10/16 bar approved), EPDM lip seal (System 3S), restrained push-fit connection
Overview of all matching egeMDR fittings
egeMDR seamless bends with single-sided push-fit socket
More Details
egeMDR seamless bends with socket coupler on both sides
More Details
egeMDR equal tees
More Details
egeMDR Reduced T-Pieces
More Details
egeMDR E-pieces, HP flange
More Details
egeMDR Repair Couplings for PE
More Details
egeMDR double push-fit couplings
More Details
egeFit® Fittings Program
Use our egeFit® fittings program as a reference guide for your planning, tendering, and ordering. It contains all fittings along with their corresponding technical data and item numbers.
Download now!